Troubleshooting Guide - Bosch FNH180K-16 Consignes De Fonctionnement/Sécurité

BM 2610034445 03-14_FNH180 3/27/14 11:52 AM Page 16
Many common problems can be solved easily by utilizing the chart below. For more serious or
persistent problems, contact a Bosch service center or call 877-BOSCH-99.
Read instruction manual first! Remove battery pack and nails from the tool
W RNING
before making adjustments, assembling accessories or servicing.
TROUBLE: TOOL WILL NOT START
PROBLEM 1. Battery pack not charged, or battery pack is damaged.
2. Battery pack not installed properly.
3. Battery pack temperature is too hot or cold for operation.
4. Terminals are dirty or damaged.
5. Tool lock-off switch is in locked position.
6. No fasteners in magazine.
7. Work Contact Element (WCE) or trigger not fully depressed.
8. Burned out switch.
9. Bent WCE.
10. Damaged internal electronics.
REMEDy 1. Charge or replace battery.
2. Confirm battery is locked and secured to the tool.
3. Let battery sit a few minutes or until it reaches normal operating
temperature.
4. See authorized service center
5. Unlock tool lock-out switch
6. Load fasteners into magazine
7. See instruction manual
8. See authorized service center
9. See authorized service center
10. See authorized service center
TROUBLE: TOOL WILL NOT ACTUATE OR FIRE
PROBLEM 1. Low battery charge or damaged battery
2. WCE or trigger released prematurely
3. Damaged trigger
4. Jammed mechanism
5. Damaged or worn return system
6. Debris in firing mechanism
8. Damaged motor or belt
8. Damaged internal electronics
REMEDy 1. Charge or replace battery
2. See instruction manual
3. See authorized service center
4. See authorized service center
5. Replace return system, see page 19 or see authorized service center
6. See authorized service center
7. See authorized service center
8. See authorized service center
All manuals and user guides at all-guides.com
Trouble Shooting Guide
(MOTOR RUNS BUT TOOL DOES NOT FIRE)
-16-