Led Light; Accessories - Black & Decker CS36BSCROTO Mode D'emploi

ENGLISH
• Before first use, the battery must be
charged for at least 10 hours.
Charging the battery (fig. B)
• Insert the charger plug (7) into the
charger connector (6).
• Plug in the charger (7).
• Leave the tool connected to the charger
for 10 hours.
The charger may hum and become warm
while charging; this is normal and does not
indicate a problem.
Warning! Do not charge the battery at
ambient temperatures below 10 °C or above
40°C.
Selecting the direction of rotation (fig. C)
For tightening screws, use forward rotation.
For loosening screws or removing a jammed
drill bit, use reverse rotation.
• To select forward rotation, push the
forward/reverse slider (2) to the forward
position.
• To select reverse rotation, push the
forward/reverse slider (2) to the
rearward position.
• To lock the tool, set the forward/reverse
slider into the centre position.
Screwdriving
• Select forward or reverse rotation using
the forward/ reverse slider (2).
• To switch the tool on, press the on/off
switch (1).
• To switch the tool off, release the on/off
switch (1).

LED light

The LED light (4) is activated automatically
when the trigger is depressed. The LED will
also illuminate when the trigger is
depressed and the forward/reverse slider
8
All manuals and user guides at all-guides.com
(Original instructions)
(2) is in the locked off position (central
position).
Hints for optimum use
Screwdriving
• Always use the correct type and size of
screwdriver bit.
• If screws are difficult to tighten, try
applying a small amount of washing liquid
or soap as a lubricant.
• Use the spindle lock to loosen very tight
screws or to firmly tighten screws.
• Always hold the tool and screwdriver bit
in a straight line with the screw.
• When screwing in wood, it is
recommended to drill a pilot hole with a
depth equal to the length of the screw. A
pilot hole guides the screw and prevents
splintering or distortion of the wood. For
the optimum size of the pilot hole, refer
to the table below.
• When screwing in hardwood, also drill a
clearance hole with a depth equal to half
the length of the screw. For the optimum
size of the clearance hole, refer to the
table below.
Screw size Pilot hole ø Pilot hole ø Clearance hole
(softwood) (hardwood
No. 6 (3.5 mm) 2.0 mm
No. 8 (4 mm) 2.5 mm
No. 10 (5 mm) 3.0 mm

Accessories

The performance of your tool depends on
the accessory used. BLACK+DECKER and
Piranha accessories are engineered to high
quality standards and designed to enhance
the performance of your tool. By using these
accessories you will get the very best from
your tool. This tool uses screwdriver bits
with a 1/4" (6.35 mm) hexagonal shank.
Piranha Super-lok accessories are designed
for use with this tool.
2.5 mm 3.6 mm
3.0 mm 4.5 mm
3.5 mm 5.0 mm