Led Indication; Jumper Settings - RISCO Group ProSound Guide D'installation Et De Programmation

All manuals and user guides at all-guides.com

LED Indication

LED Description
POWER
The power LED indicates the sounder operation
On: 13.8VDC is applied to the sounder.
Off: No power supply to the sounder.
Flash: Indicates a trouble in the sounder.
LED2
Status LED indication
On: The LED terminal block input is connected to negative (pulled to COM).
Off: No connection to the LED terminal input.
NOTE:
In BUS configuration the LED operation will be defined from the ProSYS control
panel

Jumper Settings

The sounder has three internal jumpers. Use the following table to configure the jumpers according to
the desired configuration:
Jumper
STROB
STRO B
(Default: AUTO)
AUTO
STRO B
M AN
TRIG
TRIG
(Default: C+)
C -
TRIG
+
C
TAMPER
(Default: EXT)
TAM PER
INT
TAM PER
EXT
TAM PER
Description
Defines the strobe operation mode.
AUTO: The strobe will follow the sounder activation.
MAN: The strobe will follow the triggering of the ST input.
Select the triggering command that will activate the
sounder.
C-: Use the C- terminal to trigger the sounder. (C
terminal is deactivated).
C+: Use the C+ terminal to trigger the sounder. (C
terminal is deactivated)
Defines the TAMPER output operation (Wall and cover
tampering)
INT: The TAMPER output is disabled. Use this option
when the sounder is connected in a BUS configuration.
A tamper event indication will be reported via the BUS to
the control panel.
EXT: The TAMPER output is triggered upon a tamper
event, NC configuration.
1 PIN Only: The TAMPER output is triggered upon a
tamper event, EOL configuration. In this configuration an
internal EOL 2.2 KΩ resistor, within the sounder PCB, is
applied in serial to the output.
NOTE FOR 1 PIN ONLY SETUP:
A 2.2 KΩ resistor does not have to be externally connected when
using EOL configuration.
5
+
-