auna KR-400 Mode D'emploi page 29

Connection
1. Plug in the AC cord (26) to the AC outlet. The unit will go to standby
mode and the LCD display (1) will light up.
2. Turn on the unit (14), if the LCD display (1) is on with backlighting, it
means the power supply is normal. Now your system is ready to play the
music.
Setting the clock
1. Set unit in standby mode.
2. Press the " Mem/Clk-Adj " button (8) until display will fl ash "24HR"
press the Skip Up or Skip Down button (16/21) to select the clock format
between 12 or 24Hour. Then press the " Mem/Clk-Adj " button (8).
3. The fi rst digit of " 0:00 " is fl ashing on the LCD display (1). Press Skip Up
or Skip Down button (16/21) to set the correct hour. Press " Mem/Clk-Adj
" button (8) to store the correct hour.
4. The third & fourth digit of " 00 " is fl ashing, press the Skip Up or Skip
Down button (16/21) to set the correct minutes. Then press " Mem/Clk-
Adj " button (8) to store the correct minute.
• The clock setting mode will automatically quit if no button is being
pressed in a period of about 5 seconds after pressing the " Mem/Clk-
Adj " button.
• The pre-set time will be re-set completely if dis-connecting the main
power supply except backup battery installed. You are recommended to
EN
29