Maintenance And Storage - GGP ITALY BL 2.6 E Manuel D'utilisation

10
EN

8. MAINTENANCE AND STORAGE

WARNING!
For your safety and that
of others:
– After each use, disconnect the machine
from the mains and check for damage.
– Correct maintenance is essential to maintain
the original efficiency and safety of the ma-
chine over time.
– Keep all nuts, bolts and screws tight to be
sure the equipment is in safe working con-
dition.
– Never use the machine with worn or dam-
aged parts. Damaged parts are to be re-
placed and never repaired.
– Only use original spare parts. Parts that are
not of the same quality can seriously dam-
age the equipment and compromise safety.
WARNING!
During maintenance oper-
ations unplug the machine from the mains.
1. MOTOR COOLING
To avoid overheating and damage to the motor, al-
ways keep the cooling air vents clean and free of
sawdust and debris.
9. TROUBLESHOOTING
PROBLEM
1) The motor will not – No electric power
start or will not keep
running – Intake grille missing or improperly
– Vacuum tube missing or improperly
2) The motor runs – Bag full or clogged
irregularly and lacks
in power when
revved
MAINTENANCE AND STORAGE / TROUBLESHOOTING
All manuals and user guides at all-guides.com
LIKELY CAUSE
assembled
assembled
2. ELECTRIC CABLES
WARNING!
Check the condition of the
electric cables regularly and replace them if
they are worn or their insulation looks dam-
aged.
If the electric cable is damaged, have it replaced
with a genuine spare part by a qualified techni-
cian.
3. EXTRAORDINARY MAINTENANCE
All maintenance operations not foreseen in this
manual must be performed exclusively by your
dealer.
All and any operations performed in unauthorised
centres or by unqualified persons will totally inval-
idate the warranty.
4. STORAGE
After every work stint, clean the machine thor-
oughly to remove all dust and debris, and repair or
replace any faulty parts.
The machine must be stored in a dry place away
from the elements and out of the reach of children.
SOLUTION
– Check the power connections
– Assemble and fasten the intake
grille properly (chap. 4.1)
– Assemble and fasten the vacuum
tube properly (chap. 4.2)
– Empty the bag (see chap. 7)