Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Page 6
ENGLISH
13"
20 1/8"
Figure 2.
Dimensions, CS Cartridge Series Filter -
Top View
Section 3. Installation Instructions
WARNING
Use equipment only in a pool or spa installation. Do not
connect system to an unregulated city water system or
other external source of pressurized water producing
pressures greater than 35 psi.
3.1
Filter Location
1.
Select a well-drained area, one that does not flood
when it rains. Damp, non-ventilated areas should
be avoided.
2.
Provide solid mounting for the filter and pump
system. Install system on a concrete slab or solid
concrete blocks to avoid risk of settlement. Do not
use sand to level the filter as the sand will wash
away. Filter systems can weigh up to 300 lbs.
3.
Install electrical controls at least five (5) feet from
the filter. This will allow enough room to stand
away from the filter during start-up.
4.
Allow sufficient clearance around the filter to permit
a visual inspection of the clamp ring. See Fig. 3.
WARNING
Water discharged from an improperly positioned filter
or valve can create an electrical hazard which can
cause death, serious injury or property damage.
CAUTION
Maintain your pressure gauge in good working order.
The pressure gauge is the primary indicator of how the
filter is operating.
Jandy
Pro Series, CE Single Element Cartridge Pool & Spa Filter
®
Outlet Port
Drain
Port
Inlet Port
14 1/8"
5.
Allow sufficient space above the filter to remove
the filter lid and filter element for cleaning and
servicing.
6.
Position the filter to safely direct water drainage.
Align the air release valve to safely direct purged
air or water.
7.
If the filter is to be installed below the water level
of the pool, isolation valves should be installed on
both the suction and return lines to prevent back
flow of pool water during any routine servicing
that may be required.
3.2
Filter Preparation
1.
Check carton for damage due to rough handling
in shipment. If carton or any filter components are
damaged, notify carrier immediately.
2.
Carefully remove the accessory package. Remove
the filter tank from the carton.
3.
A visual inspection of all parts should be made
now. See parts list in Section 9.
4.
Install the pressure gauge and adapter assembly to
the threaded hole marked "Pressure Gauge" at the
top of the filter See Fig. 4.
5.
Install the air release valve into the threaded
opening marked "Air Release" at the top of the
filter. See Fig. 4.
NOTE
Teflon tape is included in the accessory bag.
6" Minimum Clearance
Filter
Figure 3.
Filter Location - Top View
3.3
Filter Installation
WARNING
To avoid an electrical shock hazard, which can result
in serious injury or death, ensure that all electrical
power to the system is turned off before approaching,
inspecting or troubleshooting any leaking valves
or plumbing that may have caused other electrical
devices in the surrounding area to get wet.
|
Installation & Operation Manual
Drain
12" Minimum
Clearance
Publicité
Chapitres
Table des Matières
Dépannage
