Rose SNEAK+ Manuel D'instructions page 44

3.6 Adjustable dropouts
The frame of the Sneak+ features adjustable dropouts allowing you to tension the chain/belt without a chain tensioner.
Your bike was delivered with perfect chain/belt tension. If you want to carry out maintenance works on your bicycle
yourself, please follow the steps below to tension and release the chain/belt.
1. Loosen the axle nuts (2) of the adjustable dropouts on the right and left-hand side.
2. Thread in the tension adjusters (1) to tension the chain.
→ When tightening the tension adjusters, the dropouts are moved backwards. The chain/belt is tensioned.
→ Make sure to tighten both adjusting bolts evenly.
→ Ensure the rear wheel is straight in the rear triangle and the distance between the tyre and the right/left chainstay
is the same.
3. If you want to release the chain, loosen the adjusting bolts (1).
→ When loosening the adjusting bolts, the rear dropouts can be moved forwards. The chain is released.
→ Make sure to loosen both adjusting bolts evenly.
→ Ensure the rear wheel is straight in the rear triangle and the distance between the tyre and the right/left chainstay
is the same.
4. Tighten the axle nuts (2) of the adjustable dropouts on the right and left side to a torque of 12 Nm .
5. Make sure the wheel is properly fitted and straight.
44
1
2