Jenn-Air JDRP436HM Mode D'emploi page 9

Navigating Diagnostics Mode
While in Diagnostics Mode, the following modes are available to be selected:
FAULT CODE DISPLAY
■
MANUAL DIAGNOSTIC
■
To select a mode, rotate the Mode Selector knob clockwise until desired
mode is indicated by the UI LEDs, then press Start Button.
Fault Code Display
Top LEDs on
Manual Diagnostics
NOTE: You must exit the current mode in order to access and navigate to the
other available modes.
Top and right
LEDs on
Fault Code History Mode:
This mode provides the ability to check the last ten faults stored in the
memory. Because the UI utilizes LEDs and a speaker for communication,
errors are displayed through specific LEDs to indicate the fault and error code
(F# E#) format.
The Wi-Fi LED turns on to indicate that the fault (F) code number (#) is
■
being displayed.
The Remote LED turns on to indicate that the error (E) code number (#) is
■
being displayed.
The eight LEDs of the back-lit Mode Selector knob flash ON/OFF to
■
display the fault and errors code numbers (#'s). A number is represented
by the number of times the LED flashes ON/OFF. For example to display
"F5", Wi-Fi indicator will be ON and the Mode Selector knob LEDs will
flash ON/OFF five times.
C
A Wi-Fi LED turned on indicates Fault (F) Display mode.
B
Remote LED turned on indicates Error (E) Display mode.
C
Knob LEDs flash indicates F (Fault) or Error (E) code Numbers (#'s)
9
B
A