Jenn-Air JDRP436HM Mode D'emploi page 13

Display EXPLANATION AND RECOMMENDED PROCEDURE
F3E0 Main Oven Sensor Open or Shorted
Main oven temperature reading greater than 995°F (535°C) or less than 0°F (-18°C).
Possible Causes: Main Oven Sensor Open or Shorted. Can occur within 60-120 seconds of activating a cook or clean function or when
idling.
Recommended Procedure: See TEST #5 (RTD Main Oven Temperature Sensor) on page 21.
F3E1
Left Oven Sensor Open or Shorted
Main oven temperature reading greater than 995°F (535°C) or less than 0°F (-18°C).
Possible Causes: Left Oven Sensor Open or Shorted. Can occur within 60-120 seconds of activating a cook or clean function or when
idling.
Recommended Procedure: See TEST #6 (RTD Main Oven Temperature Sensor) on page 22.
F3E3 Main Oven Meat Probe Short-Circuit
Possible Causes: There may be a problem with the meat probe temperature sensor, the associated user interface board, or the
associated wiring.
Recommended Procedure: See TEST #7 (meat Probe & Jack or Main Oven Meat Probe short-circuit) on page 23.
F3E9 Left Oven Meat Probe Short-Circuit
Possible Cause: Problem with the meat probe temperature sensor, the associated user interface board, or the associated wiring.
Recommended Procedure: See TEST #7 (meat Probe & Jack or Left Oven Meat Probe short-circuit) on page 23.
F5E0 Main Oven Door Latch Switch
Door latch switch doesn't close or open as expected. It may occur if there is a door latch switch failure or a door latch motor failure.
Possible Causes: There may be a problem with the main oven door latch assembly, the door switch, or the associated wiring.
Recommended Procedure: Use TEST #8 on page 24, to check door switch function.
Then Use TEST #9 on page 25, to check door latch motor and latch switch function.
F5E1 Main Oven Door Latch Motor
Door latch switch doesn't close or open as expected. It may occur if there is a door latch switch failure or a door latch motor failure.
Possible Causes: There may be a problem with the main oven door latch assembly or the associated wiring.
Recommended Procedure: Use TEST #8 on page 24, to check door switch function.
Then Use TEST #9 on page 25, to check door latch motor and latch switch function.
13