Wiring Diagram; Accessories - KitchenAid 4329223 Instructions D'installation Et Guide D'utilisation Et D'entretien

Maintenance
Replacing the light bulb:
This range hood uses fluorescent lamp type F33-15W-T8 and starter type 52.
Remove the retainer clips from both ends of the light cover. Carefully slide the
cover all the way to the right. Then lower the left end of the glass below the
support flange and remove the glass by sliding it back from the left.
Install a new fluorescent light bulb.
Position the right end of the light cover over the flange and slide the cover all the
way to the right. Position the left end of the light cover over the flange and slide
the cover back to left. Reinstall the retainer clips.

Wiring diagram

Note: If a remote blower is used with this range hood,
current draw must not exceed 4 amps.
All manuals and user guides at all-guides.com
retainer
clips

Accessories

available from your dealer
Note: Instructions are included with
each kit.
Utensil Bar:
Part No. 4378619 — 15" (38 cm)
long (stainless steel only).
Charcoal Filters:
Part No. 4378623 (2 per pkg.)
Non-Vented (Recirculating) Kits*:
Part No. 4378625 (stainless steel)
Part No. 8171292 (biscuit)
Part No. 4378626 (white)
*These instructions must be read
before starting the canopy hood
installation.
support
flange
9