Assembly And Installation - Woodster st 10 I2 Traduction Du Manuel D'origine

Fig. 2
Fig. 3
b
Fig. 4
14
c
58
All manuals and user guides at all-guides.com
a
14
c

Assembly and Installation

All assembly and retrofitting work may only be performed
when the mains plug has been disconnected.
Your circular sawbench is not completely assembled for
packaging reasons.
• Open the cardboard box and remove packaging and
styrofoam material.
• Take the parts from the cardboard box.
• Take the saw from the cardboard box and put it to the
side on the ground; use cardboard as underlying to
protect the surface.
• Release the feet on both sides using the lever (fig.
2, a)
• Fold the feet outwards and secure them by means of
the locking levers (b) on both sides (Fig. 3)
Fig. 2
• Take the saw out of the carton and place it on its side
with the wheels on the ground.
• Release the feet on both sides with the lever (a).
Set up the frame horizontally, fig. 3
Unfold the feet outwards and secure them with the latch-
ing lever (b) on both sides
Mounting of the support feet Fig. 4
• Place the machine on its feet and mount the safety
feet (14) with the two hexagonal screws M6 x 40, 2
discs 6 mm, 2 spring discs 6 mm and 2 nuts M6.
• Put the machine where it is to be operated.
• With the rubber feet (c) you can adjust the stability
of the machine in that you release the lock nut, screw
the rubber feet inwards or outwards and then tighten
the lock nut again.