Woodster st 10 I2 Traduction Du Manuel D'origine page 48

48
All manuals and user guides at all-guides.com
lines.
• Keep children away from the machine when it is con-
nected to the power supply.
• Operating personal must be at least 18 years of age.
Trainees must be at least 16 years of age, but may only
operate the machine under adult supervision .
• Persons working on the machine may not be diverted
from their work.
• The machine must be equipped with a table length ex-
tension if a second person is working at the circular
sawbench removing cut workpieces. The second person
may not stand anywhere else but at the take-off table
end.
• The working space on the machine must be free of
chips and wood scrap.
• Wear only close-fitting clothes. Remove rings, bracelets
and other jewelry.
• Pay attention to the rotational direction of the motor –
see Electrical Connection.
• The safety mechanisms on the machine may not be re-
moved or rendered unusable.
• Cleaning, changing, calibrating, and setting of the
machine may only be carried out when the motor is
switched off. Pull the power supply plug and wait for
the rotating tool to completely stop.
• Switch the machine off and pull power supply plug
when rectifying any malfunctions.
• The machine must be attached to a Woodster dust ex-
tractor during all work cycles. Please observe the prop-
er use of this.
• When working on the machine, all safety mechanisms
and covers must be mounted.
• Use only sharpened, nick-free and non-deformed saw
blades.
• Circular saw blades made from superspeed steel may
not be used.
• The splitting wedge is an important safety feature. The
workpiece is fed through the splitting wedge, which
prevents the cut from closing behind the saw blade and
also prevents the workpiece from kicking back.
• Lower the cover onto the workpiece during every work-
ing operation. It must stand horizontal above the saw
blade.
• Always use a push-stick
of narrow workpieces (less than 120 mm). The
push-stick must be used to prevent you from hav-
ing to work with your hands near the sawblade.
Stop the machine to repair a failure or remove pieces
of wood which have become jammed. Disconnect the
mains plug.
• Switch the machine off and pull power supply plug
when rectifying any malfunctions.
• The table insert must be renewed when the saw slot is
worn down. Pull power supply plug.
• Before the machine is put into operation it must be
connected to a dust extractor with a flexible, non-flam-
mable suction hose. The suction should switch on auto-
matically when the machine is switched on.
• When leaving the work place, switch the motor off. Pull
the power supply plug.
• Cut off the external power supply of the machine or
for longitudinal cuts