Woodster st 10 I2 Traduction Du Manuel D'origine page 50

50
All manuals and user guides at all-guides.com
plant even if only minor changes of place are envis-
aged. Properly reconnect the machine to the supply
mains before recommissioning.
• Connection and repair work on the electrical installa-
tion may be carried out by a qualified electrician only.
• All protection and safety devices must be replaced af-
ter completing repair and maintenance procedures.
• Do not expose power tools to rain.
• Do not use power tools in a damp or wet surrounding.
• Make sure that there is sufficient illumination in the
working place.
• Do not use power tools where there is a risk of fire or
explosion.
• Avoid physical contact with parts that may cause
electric shock (for example pipes, radiators, electric
ranges, cooling unit).
• Power tools that are not in use should be stored in a
dry, elevated or safely locked place, out of the reach
of children.
• Do not pull the cable to unplug. Keep cable away from
heat, oil and sharp objects.
• Use fastening devices or a bench vice to fasten the
tools. It is safer than fastening by hand.
• Keep handles dry, clean and free of oil and fat.
• Make sure that the switch is on an off position when
plugging into the power socket.
• Only use approved and specified extension cables for
outdoors.
• Do not use power tools where the switch can not be
switched on or off.
• Circular saws can not be used for slitting (in the work
piece ended nut.)
• Only use saw-blades with a maximum speed that is not
lower than maximum spindle speed of the circular saw
bench for the material to be cut.
• Only use appliances that are suitable for transporta-
tion when moving the device. Never use the protection
device for handling or transportation.
• The upper part of the saw blades should be covered be-
fore transportation, for example with protection gear.
Additional safety instructions for laser light
The laser light and laser radiation used in this system
comply with class 1 and a maximum performance of 390
µW and 650 nm wave length. Normally laser does not
represent an optical danger, although staring into the
beam can cause flash blinding.
Warning: Do not look directly into the laser beam, since
this could represent a risk. Please observe the following
safety instructions:
• The laser may only be used and maintained in accord-
ance with the instructions of the manufacturer.
• Only point the beam onto the work piece, and never at
a person or another object.
• The laser beam must not deliberately be pointed at
persons. It must not be pointed into the eyes of a
person for more than 0.25 seconds.
• Always make sure that the laser beam is directed onto
a robust work piece without a reflecting surface. That
means that timber and materials with a rough surface
are acceptable. Shiny, reflecting plates or similar ma-