Dyson AM05 Manuel D'utilisation page 56

EN
USING YOUR DYSON HEATER
PlEASE READ THE 'ImPORTANT SAfETY INSTRUcTIONS' IN THIS
DYSON OPERATING mANUAl bEfORE PROcEEDING.
OPERATION
• The base must be fitted securely before operating. Do not dismantle or use
without the base fitted.
• The heater will not operate unless the target temperature is above the room
temperature.
• Each time the heating mode is selected, it conducts a short calibration cycle.
Airflow will be automatically controlled during this cycle. Once the calibration
cycle is complete, it will revert to the selected airflow speed.
• The heater will not oscillate when the control buttons are pressed.
• For your safety this heater is fitted with automatic cut-out switches that operate if
the heater tips over or overheats. If the switches operate, unplug the heater and
allow it to cool. Before restarting the heater check and clear any blockages and
ensure the heater is on a solid level surface.
• If power is interrupted an E1 or E5 failure message will be displayed. The heater
will need to be turned off and unplugged until the display is clear, before being
turned back on. If the problem persists, call the Dyson Helpline.
• Do not carry out any maintenance or repair work other than that shown in this
Dyson Operating Manual, or advised by the Dyson Helpline.
• Do not lubricate any part of this heater.
TIlT fUNcTION
Carefully hold the base and the top of the loop amplifier. Tilt forward or
backward for the required airflow angle.
clEANING
• Turn the heater into stand by mode/off.
• Unplug from the mains electricity supply.
• Allow to cool for 1 to 2 hours before cleaning if the heater has been in use.
• To clean, wipe with a dry or damp cloth only.
• Do not use detergents or polishes to clean the heater.
STORAGE
• When not in use, unplug from the mains electricity supply.
• Store the heater in a dry location and arrange the cable away from the traffic
area so that it will not be tripped over or damaged.
bATTERY REPlAcEmENT
cAUTION:
• Turn the heater into stand by mode and unplug from the mains electricity supply
before replacing the battery.
• Ensure the polarity is correct when installing the battery.
• Do not attempt to dismantle or charge the battery. Keep away from fire.
• Follow battery manufacturers' instructions when installing new batteries
(battery type CR 2032).
TROUblESHOOTING
• Remember: Always unplug from the mains electricity supply before inspecting
for problems.
• If the heater will not operate, first check the mains socket has electricity supply
and that the plug is properly inserted into the socket.
• If you are still experiencing problems, call the Dyson Helpline.
• To watch a short online video visit:
www.dyson.co.uk/AM05gettingstarted
GUARANTEE TERmS & cONDITION
DYSON cUSTOmER cARE
THANK YOU fOR cHOOSING TO bUY A DYSON APPlIANcE
After registering your free 2 year guarantee, your Dyson appliance will be
covered for parts and labour for 2 years from the date of purchase, subject to
the terms of the guarantee.
If you have any questions about your Dyson appliance, call the Dyson Helpline
with your serial number and details of where/when you bought the appliance.
Most questions can be solved over the phone by one of our trained Dyson
Helpline staff.
Alternatively, visit www.dyson.co.uk/support for online help, general tips and
useful information about Dyson.
If your Dyson appliance needs a service, call the Dyson Helpline so we can
discuss the available options. If your Dyson appliance is under guarantee, and
the repair is covered, it will be repaired at no cost.
Your serial number can be found on your rating plate which is on the base of
the appliance.
PlEASE REGISTER AS A DYSON APPlIANcE
OWNER
To help us ensure you receive prompt and efficient service, please register as a
Dyson appliance owner. There are two ways to do this:
• Online at www.dyson.com/register
• Telephone the Dyson Helpline.
This will confirm ownership of your Dyson appliance in the event of an insurance
loss, and enable us to contact you if necessary.
56
lImITED 2 YEAR GUARANTEE
TERmS AND cONDITIONS Of THE DYSON 2 YEAR lImITED
GUARANTEE
WHAT IS cOVERED
The repair or replacement of your Dyson appliance (at Dyson's discretion) if it
is found to be defective due to faulty materials, workmanship or function within
2 years of purchase or delivery (if any part is no longer available or out of
manufacture Dyson will replace it with a functional replacement part).
Where this appliance is sold outside of the EU, this guarantee will only be valid if
the appliance is used in the country in which it was sold.
Where this appliance is sold within the EU, this guarantee will only be valid (i) if
the appliance is used in the country in which it was sold or (ii), if the appliance is
used in Austria, Belgium, France, Germany, Ireland, Italy, Netherlands, Spain or
the United Kingdom and the same model as this appliance is sold at the same
voltage rating in the relevant country.
WHAT IS NOT cOVERED
Dyson does not guarantee the repair or replacement of a product as a result of:
• Accidental damage, faults caused by negligent use or care, misuse, neglect,
careless operation or handling of the appliance which is not in accordance with
the Dyson Operating Manual.
• Use of the appliance for anything other than normal domestic household
purposes.
• Use of parts not assembled or installed in accordance with the instructions
of Dyson.
• Use of parts and accessories which are not genuine Dyson components.
• Faulty installation (except where installed by Dyson).
• Repairs or alterations carried out by parties other than Dyson or its authorised
agents.
• Damage from external sources such as transit, weather, electrical outages or
power surges.
• Failures caused by circumstances outside Dyson's control.
• Damage as a result of use not in accordance with the rating plate.
• Blockages – please refer to the Dyson Operating Manual for details of how to
look for and clear blockages.
• Normal wear and tear, such as the battery.
If you are in any doubt as to what is covered by your guarantee, please
contact Dyson.
SUmmARY Of cOVER
• The guarantee becomes effective at the date of purchase (or the date of delivery
if this is later).
• You must provide proof of (both the original and any subsequent) delivery/purchase
before any work can be carried out on your Dyson appliance. Without this proof,
any work carried out will be chargeable. Keep your receipt or delivery note.
• All work will be carried out by Dyson or its authorised agents.
• Any parts which are replaced by Dyson will become the property of Dyson.
• The repair or replacement of your Dyson appliance under guarantee will not
extend the period of guarantee.
• The guarantee provides benefits which are additional to and do not affect your
statutory rights as a consumer.
AbOUT YOUR PRIVAcY
• Your information will be held by Dyson Limited and its agents for promotional,
marketing and servicing purposes.
• If your personal details change, if you change your mind about any of your
marketing preferences or if you have any queries about how we use your
information, please contact Dyson Limited.
• For more information on how we protect your privacy, please see our privacy
policy on the Dyson website.
DISPOSAl INfORmATION
Dyson products are made from high grade recyclable materials. Please dispose
of this product responsibly and recycle where possible.
PRODUcT INfORmATION
Please note: Small details may vary from those shown.
Net weight: 2.43kg
fR/bE/cH
UTIlISATION DU cHAUffAGE DYSON
VEUIllEZ lIRE ATTENTIVEmENT lES cONSIGNES DE SÉcURITÉ
ImPORTANTES DE cE mANUEl D'UTIlISATION DYSON AVANT DE
cONTINUER.
fONcTIONNEmENT
• La base doit être bien fixée avant la mise en marche de l'appareil. Ne pas le
démonter ou l'utiliser avec la base non fixée.
• Le chauffage ne fonctionnera pas tant que la température ciblée est inférieure à
la température ambiante de la pièce.
• Lorsque le mode chauffage est sélectionné, un bref cycle d'étalonnage
s'amorce. Le flux d'air est automatiquement régulé durant ce cycle. Une fois le
cycle d'étalonnage terminé, le flux d'air retrouve la vitesse sélectionnée.
• Le chauffage n'oscillera pas si les boutons de commandes sont enfoncés.
• Pour la sécurité de l'utilisateur, cet appareil est équipé de coupe-circuits
automatiques qui s'activent si le chauffage est renversé ou en cas de surchauffe
de ce dernier. Si les coupe-circuits sont activés, débrancher le chauffage et
le laisser refroidir. Avant de rallumer le chauffage, vérifier et dégager toute
obstruction et s'assurer que le chauffage est sur une surface dure et plane.