Thermostat Control; Heating Mode - Dyson AM05 Manuel D'utilisation

Controls
1. Power on
Each time the heating mode is selected, it conducts a
short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration
cycle is complete, it will revert to the selected airflow
speed.
On first use, the heater will default to a temperature
1°C higher than the current room temperature.
Thereafter, the heater will remember the last target
temperature set.

Heating mode

Spot heat
Select a low flow of air.
Whole room
Select a high flow of air.
For best results turn on the oscillation control.
38

2. Thermostat control

Select the desired room temperature. Pressing red
increases the target temperature, blue decreases
it. The heater will not operate unless the target
temperature is above the room temperature.
Cool air mode
Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change from
red to blue. To adjust the airflow speed use the airflow
speed control.
To return to heating mode
Press the red thermostat control button until the digital display
shows the desired target temperature. The power button light
will change from blue to red.