Configuring The Different Parameters; Focusing The Camera - Fermax DUOX Manuel D'installation

Configuring the different Parameters

You can configure a parameter by entering the two position digits; you will then hear a
beep and then you must enter the desired value (1, 2, 3 or 4 digits relative to the parameter).
If the code is correct, a confirmation tone sounds (beep-beep) and the new value is
saved. If not correct you will hear the error sound (bop).
Position
00 ... 12 (beep) +
Examples:
• Change the programming code to 1122:
09 (beep) 1122 (beep-beep)
• Changing the lock-release time to 2 seconds:
01 (beep) 02 (beep-beep)
In order to exit the programming press 'A' when we are entering the menu´s position
number. You can also exit by waiting 60 seconds without pressing any key and a beep-
beep tone will sound.
NOTES:
- If trying to assign the same programming code as the lock-release code, it is not
allowed and a call error tone sounds (bop).
-To deactivate the opening code you must enter the value AAAA in position 08
- When configuring a zero value in «Volume Monitoring" you mute the button, call,
and other monitorings of the street panel.
Camera focus
The following images show the value represented in each of the video capture segments.
If you select a value of 9, this captures the whole image.
1 1
3 3
6
Possible Values
1, 2, 3 or 4 digits (beep-beep)
0
5
7
8
(digits relative to the selected parameter).
2 2
9
4 4
Pag 57