Samsung HT-E4500K Guide D'utilisation page 32

Settings
< Getting the Network Settings Values >
You can view your Network Settings values on
most Windows computers. To view the Network
Settings values, follow these steps:
• Windows XP
1 · Right click the Network icon on the bottom
right of the Windows desktop.
2 · In the pop-up menu, click Status.
3 · On the dialog that appears, click the Support
tab.
4 · On the Support tab, click the Details button.
The Network settings are displayed.
• Windows 7
1 · Click the Network icon on the bottom right of
the Windows desktop.
2 · In the pop-up menu, click Network and
Sharing Center.
3 · On the dialog that appears, click the Local
Area Connection or Wireless Network
Connection depending on your network
connection.
4 · On the Support tab, click the Details button.
The Network settings are displayed.
| |
NOTE
\ Depending on your Windows version, the information may
differ.
Wireless Network
• First, insert the Samsung Wireless LAN Adapter to the
product.
You can setup a wireless network two ways:
- Wireless(General)
- WPS(PBC)
Wireless(General) includes both Automatic and
Manual setup procedures.
32
|
English
Wireless(General) - Automatic
Network Settings
Samsung Wireless LAN Adapter connected.
Press Start to configure your wireless network settings.
If you want to connect to your wired network, plug in a
network cable.
1 · Select the Start in the Network Settings
menu. And then press the E button.
The product searches for and then displays a
list of the available networks.
2 · Select the desired network, and then press
the E button. Select Next, and then press
the E button again.
The Security screen appears.
3 · On the Security screen, enter your network's
Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter letters
by selecting a letter with an arrow button, and
then press E .
4 · When done, select Next at the right of the
screen, and then press E .
5 · The Network Status screen appears. The
product verifies the network connection and
then connects to the network. When done,
highlight OK, and then press E .
| NOTE |
\ You should be able to find the Security Code or Pass
Phrase on one of the set up screens you used to set up
your router or modem.
Wireless(General) - Manual
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
1 · Select Wireless(General) in the Network
Settings menu, and then press the E
button. Select Next, and then press the E
button again.
The Network Status screen appears.
The product attempts to verify the network
connection and fails.
Start
Cancel