Installing The Speakers On The Tallboy Stand - Samsung HT-E4500K Guide D'utilisation

Installing the Speakers on the Tallboy Stand

* HT-E4530K only - Front Speakers
* HT-E4550K only - Front/Surround Speakers
1. Turn the Stand Base upside-dowon and
connect it to the Stand.
2. Insert screws clockwise into the three holes
marked using a screwdriver as shown in the
illustration.
3. Straighten a supplied speaker wire and put in
the hole on the Center of Stand Base.
4. Connect the upper Speaker to the assembled
Stand.
5. Insert a screw clockwise into the hole on the
rear of the speaker using a screwdriver.
And then connect a speaker cable.
6. This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.
Connecting The Speakers
1. Match each speaker cable bundle to the correct speaker by matching the
Color coded plug on each bundle to the Colored sticker on the bottom of
each speaker.
2. To attach speaker wire to each speaker:
a. Press down the red tab on the back of the speaker, insert the red wire,
and then release the tab.
b. Press down the black tab on the back of the speaker, insert the black
wire, and then release the tab.
3. Connect the speaker wire plugs to the back of the product by matching
the Colors of the speaker plugs to the Colors of the speaker jacks.
1
Stand Base
Stand
3
5
2
4
Speaker
Stand
6
Black
Red
17
|
English