Allshare Settings - Samsung HT-E4500K Guide D'utilisation

2 · Select Add Network on the bottom of the
screen, and then press E . Select Next, and
then press the E button again.
The Add Network Settings screen appears.
3 · Use the keypad on your remote to enter the
Wireless Router Name. Select Next, and
then press the E button when done. The
Security Type screen appears.
| NOTE |
\ Enter numbers in the Wireless Router Name by pressing
the number buttons on your remote.
\ Enter letters by selecting a letter using the ▲▼◀▶
buttons, and then press E button.
\ To display capital letters (or redisplay small letters if
capital letters are displayed), select A/a, and then press
the E button.
\ To display symbols and punctuation, select , and then
press the E button. To redisplay letters, select A/a, and
then press the E button.
4 · Select the Security Code protocol you are
using on your router, and then press the E
button. Select Next, and then press the E
button again. The Security screen appears.
5 · On the Security screen, enter your network's
Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter letters
by selecting a letter with the ▲▼◀▶
buttons, and then press E . For additional
instructions, see the Notes after Step 3.
6 · When done, select Next at the right of the
screen, and then press E .
7 · The Network Status screen appears. The
product verifies the network connection and
then connects to the network. When it is
done, highlight OK, and then press E .
WPS(PBC)
Network Settings
Samsung Wireless LAN Adapter connected.
Press Start to configure your wireless network settings.
If you want to connect to your wired network, plug in a
network cable.
1 · Select the Start in the Network Settings
menu. And then press the E button.
2 · Select WPS(PBC), and then press the E
button.
3 · Press the WPS(PBC) button on your
router within two minutes. Your product
automatically acquires all the network
settings values it needs and connects to your
network.
The Network Status screen appears. The
product verifies the network connection and
then connects to the network. When done,
highlight OK, and then press E .

AllShare Settings

The AllShare Settings screen lists your network
connected AllShare devices and their IP
addresses. Through this screen, you can allow
a device to access the product, deny access, or
delete the device from the AllShare list.
1 · In the Home screen, select Settings, and
then press the E button.
2 · Select Network, and then press the E
button.
3 · Select AllShare Settngs, and then press the
E button.
4 · Select a device, and then press the E
button. The AllShare Settings pop-up
appears.
5 · Select Allow, Deny, or Delete from List, and
then press the E button.
The AllShare Settings screen only displays devices
if you have established networked connections
to AllShare devices. For more information about
AllShare networked devices, see pages 36~37.
Start
Cancel
33
|
English