Installing The Speakers On The Tallboy Stand; Connecting The Speakers - Samsung HT-E4500 Manuel D'utilisation

Installing the Speakers on the Tallboy Stand

* HT-E4530 only - Front Speakers
* HT-E4550 only - Front/Surround Speakers
1. Turn the Stand Base upside-down and
connect it to the Stand.
2. Use the driver to combine the screws on the
3 marked holes.
3. Straighten a supplied speaker wire and put in
the hole on the centre of Stand Base.
4. Connect the upper Speaker to the assembled
Stand.
5. Insert a screw clockwise into the hole on the
rear of the speaker using a screwdriver.
And then connect a speaker cable.
6. This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.

Connecting The Speakers

* HT-E4530 only - Front Speakers
* HT-E4550 only - Front/Surround Speakers
1. Match each speaker cable bundle to the correct speaker by matching the
colour coded plug on each bundle to the coloured sticker on the bottom
of each speaker.
2. To attach speaker wire to each speaker:
a. Press down the red tab on the back of the speaker, insert the red wire,
and then release the tab.
b. Press down the black tab on the back of the speaker, insert the black
wire, and then release the tab.
3. Connect the speaker wire plugs to the back of the product by matching
the colours of the speaker plugs to the colours of the speaker jacks.
1
Stand Base
Stand
3
5
2
4
Speaker
Stand
6
Black
Red
17
|
English