Electrical Safety - Black & Decker NSVA315J Manuel D'utilisation

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
# appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charger is intended for indoor use only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code.
Read all of this manual carefully before
using the appliance
Only use with charger S003AQ-15 /
SSC-150015
S003AQ-15 / SSC-150015
Features
This tool includes some or all of the following features.
1. Extension pole release button
2. On/Off switch
3. Dust chamber release button
4. Dust chamber
5. Floor head connector
6. Floor head
7. Charger
8. Extension pole
9. Handle
Assembly (Fig. A, B, C)
Push the handle (9) firmly into the extension pole (8) as
u
shown in figure A.
Note: This process only needs to be performed once, as you
will be unable to remove the handle from the extension pole
once it is locked in place.
Push the extension pole (8) into the opening on the
u
Dustbuster until it clicks into place as shown in figure B.
®
To release the extension pole from the Dustbuster
the extension pole release button (1).
Fit the floor head (6) to the opening on the dust chamber
u
(4) at the front of the Dustbuster
connector (5) as shown in figure C.
Charging the battery (Fig. D, E)
Place the charger (7) into the charging port (7a) at the rear
u
of the unit and plug into the electrical outlet.
press
®
unit via the floor head
®
(Original instructions)
Switch the electrical outlet on.
u
Use
Before first use, the battery must be charged for at least
u
10 hours.
Switching on and off (Fig. F
To switch the appliance on, push the on/off switch (2) to
u
the forward position.
To switch the appliance off, return the on/off switch (2) to
u
the back position.
Warning! Never pick up wet applications with these units.
Optimising the suction force
In order to keep the suction force optimised, the filters must be
cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filters (Fig. G, H, I, J).
Press the dust chamber release button (3)and remove the
u
dust chamber (4) from the motor unit as shown in figure G.
While holding the dust chamber (4) over a suitable
u
receptacle, pull out the filter (10).
Shake the dust chamber (4) over a suitable receptacle to
u
empty the contents as shown in figure I.
To replace the dust bowl, push it back onto the motor unit
u
until it locks firmly into position.
Warning! Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean
filters.
The dust bowls and filters can be washed in warm soapy
u
water.
Make sure that the filters and the dust bowl are dry before
u
re-fitting.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged.
Replacement filters are available from your BLACK+DECKER
dealer:
Storage (Fig. K)
Your BLACK+DECKER NVSA315J can be hung from a wall
fitting (not supplied) by using the hole in the handle (11) as
shown in figure K.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
ENGLISH
)
7