Hilti DAG115-S Mode D'emploi page 18

Obligation signs
Wear eye Wear a hard
protection. hat
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Watts Hertz
Revolutions Rated speed
per minute
2 Description
2.1 Use of the product as directed
The power tool is designed for cutting and grinding metal and mineral materials without use of water.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Working with metals: Cutting, grinding.
Working with mineral materials: Cutting, slitting and grinding.
Use only discs (abrasive grinding discs, abrasive cutting discs, etc.) that are approved for use at a speed of at least
11000/min, with a maximum thickness of 6.4 mm (grinding discs) or 2.5 mm (cutting discs) and a diameter of max.115
mm.
Use only synthetic resin-bonded, fiber-reinforced grinding discs or cutting discs approved for use at a peripheral
speed of 80 m/sec or diamond cutting discs approved for use at a peripheral speed of 80 m/sec.
The power tool may be used only for dry cutting or grinding.
Cutting or grinding materials containing asbestos is not permissible.
Nationally applicable industrial safety regulations must be observed.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
All manuals and user guides at all-guides.com
Wear ear Wear
protection protective
gloves
Volts Amps
Alternating Revolutions
current per minute
Diameter Double
insulated
Location of identification data on the power tool
The type designation, item number, year of manufacture
and technical status can be found on the type identific-
ation plate on the machine or tool. The serial no. can
be found on the underside of the motor housing. Make
a note of this data in your operating instructions and
always refer to it when making an enquiry to your Hilti
representative or service department.
Type:
Generation: 02
Serial no.:
en
15