visomat comfort III Mode D'emploi page 40

C
5. Calling up the memory
Measured results are automatically stored in the
memory. The memory can store up to 30 results
and the average value.
When more than 30 measured values have been
stored, the oldest value (No. 30) is deleted so that
the most recent value (No. 1) can be recorded.
Press the memory button to recall data.
The average value of the stored results saved is
displayed with "A" followed by the most recently
measured value. If no value is stored, nothing is
displayed.
Repeatedly press the button to call up the other
measured values. The stored data are displayed
for about 30 seconds. The monitor will then switch
itself off.
GB-40
All manuals and user guides at all-guides.com
Operation of the device
6. Deleting the memory
To delete individual measurements, press the
Memory button a number of times to call up
the measurement required, press again and
keep the button pressed for 8 - 10 seconds
until the measurement has disappeared. To
delete the entire memory, call up the mean,
press the Memory button again and keep
it pressed until the mean has disappeared
(8-10 sec).
Press the Start/Stop button and switch the
monitor off.
If the display flashes, the deletion process has not
been completed and must be repeated.
Record the figures saved in your blood pressure pass.
Over a lengthy period this will provide you with a bet-
ter picture of your blood pressure situation, which
you may wish to discuss with your doctor.