GGP Sweden XK 160 HD Mode D'emploi page 37

accompanying documentation
- carelessness
- incorrect and non-permitted use or assembly
- the use of non-genuine spare parts
- the use of accessories not supplied or approved
by GGP
Neither does the guarantee cover:
- wearing components such as blades, belts,
wheels and cables
- normal wear
- engine and transmission. These are covered by
the appropriate manufacturer's guarantees with
separate terms and conditions.
The purchaser is covered by each country's
national laws. The rights to which the purchaser is
entitled with the support of these laws are not
restricted by this guarantee.
PRODUCT IDENTITY
The identity of the product is determined by two
parts:
1. The machine's item and serial numbers:
2. The engine's model, type and serial numbers:
Found on the machine's fan housing as illustrated:
Use these identification terms during all contact
with service workshops and when purchasing
spare parts.
As soon as possible after acquiring the machine,
the above number should be written in on the last
page of this publication.
ENGLISH
ENVIRONMENT
For environmental reasons, we recommend that
particular attention is given to the following
points:
• Always use Alkylate petrol ("Environmental
petrol").
• Always use a funnel and/or a petrol can with
overfill protection to avoid spillage when filling
with petrol.
• Do not fill the petrol tank right to the top.
• Do not fill too much engine and/or transmission
oil (see user instructions for the correct
amount).
• Collect up all oil during oil changes. Do not
spill any. Hand in the oil to a recycling station.
• Do not discard replaced oil filters with normal
rubbish. Hand them in to a recycling station.
• Do not discard replaced lead batteries with
normal rubbish. Hand in to a battery collection
point for recycling.
• Replace the silencer if it is broken. Always use
original spare parts when carrying out repairs.
• If the machine was originally equipped with a
catalytic converter and this is broken, a new
catalytic converter must be installed after
removing the old one.
• Always get a specialist to adjust the carburettor
if necessary.
• Clean the air filter according to the instructions
given (see user instructions).
Manufacturer reserves the right to make alterations to
the product without prior notification.
GB
37