Using The Led Light; Using The Folding Handle - Makita 6723DW Mode D'emploi

Reverse
(Removing screws)
6
2. To rotate the bit holder in a reverse (removing screws) direction, press the left hand side of
the On/Off switch marked
3. Release the On/Off switch to stop the screwdriver.
NOTE:
Always use sharp good quality screwdriver bits. The performance and safety of the screwdriver is
dependant on the quality of the bits used.

4. Using the LED light

7

5. Using the folding handle

8
. See figure 6.
Press
The screwdriver is equipped with an LED light to
assist when operating the screwdriver in dark
recesses or other poorly lit areas. To switch the
LED light On, press the LED light On/Off switch
as shown in figure 7.
To switch the LED light Off press the LED light
On/Off switch again.
The screwdriver is equipped with a folding
handle for either in-line, or pistol grip use. When
folded into the pistol grip position it gives
assistance when used in areas that may have
restricted access. See figure 8.
To use the folding handle, grip the lower handle
with one hand and move the upper handle to the
desired position with the other hand.
9