Inserting Screwdriver Bits; Operating The On/Off Switch - Makita 6723DW Mode D'emploi

OPERATING INSTRUCTIONS
WARNING!
Do not press the On/Off switch when removing, or installing a screwdriver
bit.

2. Inserting screwdriver bits

To insert a screwdriver bit, push it firmly into the screwdriver bit holder. See figures 3 & 4.
3
To remove a screwdriver bit, pull it firmly out of the screwdriver bit holder.
If required the magnetic bit holder supplied with the screwdriver, can be inserted into the
screwdriver bit holder and the screwdriver bit can then be inserted into the magnetic bit holder.
This cordless screwdriver is supplied with an 80 piece accessory pack. See page 3 for details.
NOTE:
Replacement screwdriver bits can be obtained from most tool or DIY stores.
WARNING!
Before operating the On/Off switch, make sure that you have read all of
the safety instructions on pages 4, 5 and 6.

3. Operating the On/Off switch

The On/Off switch is used to start the screwdriver. It also controls the direction in which the bit
holder rotates.
Forward
(Driving)
5
1. To rotate the bit holder in a forward (driving) direction, press the right hand side of the On/Off
switch marked
8
. See figure 5.
4