Hilti TE 6-A36 Mode D'emploi page 14

3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶ The product is ready for use.
5.8 Removing the accessory tool
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.9 Overhead work
▶ Fit the DCD dust control ring for overhead work.
5.10 Chisel positioning
▶ Set the function switch to the
6 Types of work
6.1 Function selector switch
▶ Set the function selector switch to the desired working position.
▶ Do not operate the function selector switch while the motor is running. Risk of damage!
6.2 Forward/reverse
▶ Set the forward/reverse switch to the desired direction of rotation.
6.3 Drilling without hammer action
▶ Set the function selector switch to the
6.4 Drilling with hammer action
▶ Set the function selector switch to the
6.5 Chiseling
▶ Set the function switch to the
▶ For optimum motor cooling, select the forward direction, i.e. clockwise (direction of rotation for
drilling).
7 Care and maintenance
7.1 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
8 English
7
8
position.
8
9
position.
position.
position.
2100249
*2100249*