Intended Use - ResMed AirFit P10 Mode D'emploi

English
NASAL PILLOWS SYSTEM
This document provides the user instructions for:
• AirFit P10 (blue headgear) and AirFit P10 for Her (pink headgear)
collectively referred to as AirFit P10.

Intended use

The mask directs airflow noninvasively to a patient from a positive
airway pressure device such as a continuous positive airway (CPAP)
or bilevel system.
The mask is intended for:
• Patients (>30 kg) for whom positive airway pressure has been
prescribed
• single patient re-use in the home environment and multipatient
re-use in the hospital/institutional environment.
Using the mask
• Refer to the Technical specifications section in this user guide for
mask setting options.
• Follow the instructions provided by your physician or sleep
therapist.
• To fit, adjust, remove, disassemble or reassemble your mask, follow
the illustrations at the front of this guide.
• Do not overtighten the headgear straps. If you feel air leaks you
may need to:
– refit or reposition your mask
– adjust your headgear
– check that your mask is assembled correctly
– contact your physician or sleep therapist to have your mask
refitted.
• For a full list of compatible devices and mask setting options, see
the "Mask/Device Compatability List" on www.resmed.com on
the Products page under Service & Support.
• The mask system does not contain natural rubber latex, PVC, DEHP
or phthalates materials.
Cleaning the mask at home
• The mask and headgear can only be handwashed.
• The mask vent may discolour over time. Follow the cleaning
instructions in this guide to maintain performance and safety of
the mask.
Daily/After each use
• To optimise the mask seal, remove facial oils from the pillows
before use.
• Handwash the mask by rubbing gently in warm (30°C) water using
mild soap.
• Rinse all components well with drinking quality water and allow
them to air dry out of direct sunlight. Dry the vent by gently
wiping with a cloth.
• If the vent is blocked, clean it with a soft bristle brush.
• Inspect each component and, if required, repeat washing until
visually clean.
• When all components including the vent are dry, reassemble
according to the reassembly instructions.
Weekly
Handwash the headgear in warm (30°C) water using mild soap. It
may be washed without being disassembled. Rinse well and allow it
to air dry out of direct sunlight.
6