arjo Enterprise ENT-ACC24 Mode D'emploi page 4

English
Installation & use
Insert the base of the IV pole into either of the sockets (1) at the head end of the bed. Twist
the IV pole so that the notch (2) locates over the pin at the bottom of the socket.
To adjust the height of the pole: Push up the locking collar (3) and slide the top section of
the IV pole up or down to the required height. The pole can be adjusted with one hand as
shown.
3
2
1
After use: remove all equipment from the hooks. Adjust the IV pole to minimum height and
pull the pole vertically out of the socket.
WARNING
A clinically qualified person should assess the risks involved before transporting a
patient while IV equipment is in use
When moving the bed, do not allow the IV pole or associated equipment to come into
contact with surrounding objects or people as this may cause injury and/or
equipment damage
Do not use the installed IV pole to move or manoeuvre the bed
When the IV pole is installed, the head end panel should only be removed after
assessment by a clinically qualified person, as the gap between the IV pole and
safety side constitutes a potential entrapment hazard
Do not use the IV pole or hooks to support items or equipment other
than fluid bags, syringe drivers, etc.
2