Adjusting The Grinding Unit - GOWEIL MS 100 Manuel D'utilisation

Knife sharpener MS 100
Operation
.
and rests safely against the end stop bolts. and rests safely against the end stop bolts.
2.
3.
6.11 Positioning knive s for Krone VP 1500 and VP 1800 round bale presses
Shown below are special setting specifications for knives used in Krone VP 1500 and VP 1800 round bale Shown below are special setting specifications for
presses!
6.11.1 Setting the adjusting plate/ knife
270 mm
The specified dimension is merely intended as a guide value! specified dimension is merely intended as a guide value!

6.11.2 Adjusting the grinding unit

6.11.2.1 Retaining plate – adjusting distance, grinding angle
The specified dimensions are merely intended as guide values! The specified dimensions are merely intended as guide values!
275mm
24
All manuals and user guides at all-guides.com
Also make sure that the curved knife is securely clamped into the horizontal clamping device Also make sure that the curved
Level the cup grinding wheel an Level the cup grinding wheel and the cutting surface into a horizontal position (0 degrees) ( d the cutting surface into a horizontal position (0 degrees) ( page
21 , item 6.6 „Adjusting the grinding angle") , item 6.6 „Adjusting the grinding angle")
The work flow is the same as described The work flow is the same as described on page 22, item 6.8.1 "Work flow".
NOTICE! NOTICE!
If not needed, the linear grinding unit can be folded away. If not needed, the linear grinding unit can be folded
TIP!
Setting the right grinding angle is easier for new knives. Setting the right grinding angle is easier for new
s for Krone VP 1500 and VP 1800 round bale presses s for Krone VP 1500 and VP 1800 round bale presses
IMPORTANT! IMPORTANT!
The specifications below are guide values as they may vary slightly depending on The specifications below are guide values as they may vary slightly depending on The specifications below are guide values as they may vary slightly depending on
the wear on the knives! the wear on the
knife position on the adjusting plate
Correct position of the knife!
adjusting distance, grinding angle
IMPORTANT! IMPORTANT!
You must turn the rotary unit You must turn the rotary unit of the grinding unit by 180°! See page 20
"Adjusting the grinding unit" "Adjusting the grinding unit"
is securely clamped into the horizontal clamping device
Krone VP 1500 and VP 1800 round bale
40mm
20 , item 6.5
10.03.2009