GOWEIL MS 100 Manuel D'utilisation page 59

6.9 Switching the machine off Switching the machine off
1.
6.10 Linear grinding unit (additional equipment) Linear grinding unit (additional equipment)
The linear grinding unit can be used to sharpen straight knives. The linear grinding unit can be used to sharpen straight
Sharpening straight knife
and mount it on the angle table of the linear grinding unit. and mount it on the angle table of the linear grinding unit.
6.10.1 Attaching the linear grinding unit Attaching the linear grinding unit
See drawing "Attaching linear grinding unit" See drawing "Attaching linear grinding unit"
Tightening torque for M6 => 10Nm . Tightening torque for M6 => 10Nm
Tightening torque for M8 => 25Nm . Tightening torque for M8 => 25Nm
6.10.2 Adjusting the linear grinding unit Adjusting the linear grinding unit
Make the adjustments as described on pages 19, item 6. 3 "Preparations" to 21 Make the adjustments as described
rotation limiter" .
.
and rests safely against the end stop bolts. and rests safely against the end stop bolts.
1.
10.03.2009
All manuals and user guides at all-guides.com
Switch the machine off using the Switch the machine off using the
OFF switch (red button "0"). OFF switch (red button "0").
knife s merely requires that you remove the adjusting plate from the grinding table
.
IMPORTANT!
When sharpening straight knive s, make sure the surface to be ground is
horizontal. This means that the cup grinding wheel must be aligned horizontally horizontal. This means that the cup grinding wheel must be aligned horizontally
as well!
Also make sure that the curved knife is securely clamped into the horizontal clamping device Also make sure that the curved
Align the linear grinding unit according to the grinding angle. Both angle straps have four recesses Align the linear grinding unit according to the grinding angle. Both angle straps have four recesses Align the linear grinding unit according to the grinding angle. Both angle straps have four recesses
each.
The topmost recess is equal to 0 degrees (horizontal) on the angle table. The other recesses are The topmost recess is equal to 0 degrees (horizontal) on the angle table. The other recesses are The topmost recess is equal to 0 degrees (horizontal) on the angle table. The other recesses are
positioned in 15 degree increments. positioned in 15 degree increments.
Undo quick quick -action locking screws – adjust angle – tighten quick- action locking screw.
Knife sharpener Knife sharpener MS 100
2. Press the lockable cover of Press the lockable cover of
the emergency stop switch the emergency stop switch
closed until it closed until it locks into
place. place.
3. Pull the power plug. Pull the power plug.
the adjusting plate from the grinding table
3 "Preparations" to 21 , item 6.7 "Adjusting the
s, make sure the surface to be ground is
is securely clamped into the horizontal clamping device
action locking screw.
Operation
23