GOWEIL MS 100 Manuel D'utilisation page 55

6.3 Preparations
Pos : 7.9 /KN2006- SM/nL.......... Seitenumbr uc h .......... @ 8\mod_1141998334703_0.doc @ 75489
6.3.1 Startup
1. Place the machine on a stable and level surface. Place the machine on a stable and level surface.
2 . Attach the power plug . Attach the power plug
Plug the power plug into the designated socket. Plug the power plug into the designated socket.
3 . Check the cup grinding wheel . Check the cup grinding wheel
6.4 Positioning curved kniv
Pos : 7.18 /KN 2006-SM /Bedi enung/007 1.1 Stillsetzen i m N otfall --> Anl age und grösser e M asc hine @ 9\mod_1144432835796_1.doc @ 86788
In dangerous situations, the movements of the machine must be stopped and the power supply cut off as In dangerous situations, the movements of the machine must be stopped and the power supply cut off as In dangerous situations, the movements of the machine must be stopped and the power supply cut off as
quickly as possible. Also make sure that the curved
rests safely against the end stop bolts. rests safely against the end stop bolts.
10.03.2009
All manuals and user guides at all-guides.com
WARNING! WARNING!
Risk of injury due to incorrect setup! Risk of injury due to incorrect setup!
Setting the machine up improperly may lead to serious Setting the machine up improperly may lead to serious injuries.
Therefore: Therefore:
– Make sure there is sufficient room to operate the machine. Make sure there is sufficient room to operate the machine.
WARNING! WARNING!
Risk of electric shock when handling cables improperly! Risk of electric shock when handling cables improperly!
WARNING! WARNING!
Always check the cup grinding wheel before starting up the machine! Always check the cup grinding wheel before starting up the machine! Always check the cup grinding wheel before starting up the machine!
kniv es
Also make sure that the curved knife is securely clamped into the
1. The curved The curved knife must be
securely placed in the securely placed in the
center of the adjusting center of the adjusting
plate. Smooth cutting plate. Smooth cutting
surface at the top, surface at the top,
serrated edge at the serrated edge at the
bottom. bottom.
3. Position the end stop Position the end stop
bolts as far out as bolts as far out as
possible and fix them in possible and fix them in
place.
Knife sharpener MS 100 Knife sharpener
is securely clamped into the clamping device and
2. The cutting surface must
protrude by approx. 0.79
in from the adjusting
plate.
4. Position the clamping
device in such a way that
the knife holder securely
clamps the curved knife
you want to sharpen
(approx. half of the
overlap)
Operation
19