Harmony DREAMTIME 2 Manuel D'instructions page 23

DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
BOOSTER WITHOUT BACKREST
See "Assembling/Disassembling back support" (pg. 15)
for instructions for removing the backrest.
1. Place the booster seat firmly against the back of a
forward-facing vehicle seat in a position equipped
with a vehicle lap-and-shoulder belt and headrest.
2. Have your child sit on the booster car seat with their
back flat against the vehicle seat.
3. Thread both sides of the lap belt and the lower end
of the shoulder belt of the 3-point lap-and-shoulder
belt system UNDER BOTH booster seat armrests, and
ensure that the belt is snug across child's hips just
touching their thighs and is NOT across their stomach.
4. Buckle vehicle seat belt into place.
Ensure the buckle is secure by
gently pulling on it.
! BOTH SIDES OF THE LAP BELT
AND THE LOWER END OF THE
SHOULDER
UNDER BOTH ARMRESTS.
! THE VEHICLE'S
BELT MUST LIE ACROSS THE CHILD'S SHOULDER
AND LAY ACROSS THE CHEST – NOT THE FACE
OR NECK. If the belt does not lie properly across
the child's shoulder and chest, the RED shoulder
belt guide clip MUST be used to ensure proper
WARNING!
!
BELT MUST PASS
SHOULDER
22