Installation - Booster Without Backrest - Harmony DREAMTIME ELITE Manuel D'instructions

belt under the armrest on the buckle side ❸.
ENSURE that the belt is snug across the child's hips.
It is important to ensure that any lap strap is worn
low down, so that the pelvis is firmly engaged,
just touching their thighs and is NOT across their
stomach.
6. Buckle the vehicle seat belt into place and ensure it is
secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS UNDER THE ARMREST
ON THE BUCKLE SIDE.
!
Any straps holding the restraint to the vehicle should be
tight, any straps restraining the child should be adjusted
to the child's body, and all straps should not be twisted.
! NEVER USE A VEHICLE LAP-ONLY BELT WHEN USING
THIS BOOSTER SEAT.
! WARNING: To avoid possible entanglement hazard,
see "Entanglement with vehicle seat belt".

INSTALLATION - BOOSTER WITHOUT BACKREST

See "Assembling/disassembling
instructions for removing the backrest.
1. Place the booster seat flush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped with
a 3-point lap-and-shoulder belt. Booster must be
level, stable and not rock side-to-side (see "Vehicle
seating positions").
2. Place child on the
booster
child's back flat against
the vehicle seat.
3. Thread both sides of the lap belt
under BOTH armrests. Thread the
lower end of the shoulder belt under
the armrest on the buckle side ❶.
seat with
backrest" for
❶
24