Hendi 263501 Mode D'emploi page 6

Cleaning and Maintenance
Attention! Edible oil remaining on the grill is
very hot after use of the appliance.
Risk of Electric Shock!
• Do not let water or liquids enter the appliance.
• Always disconnect the power plug before cleaning.
Risk of burns!
• Make sure the grilling plates cool down before
cleaning.
• ATTENTION! Always unplug the appliance and
cool down before cleaning.
• Clean the appliance after each use.
Transportation and Storage
• Please handle with care during transport, never
transport or store the appliance up side down or
on it's sides. This may cause damage to the ap-
pliance.
Troubleshooting
Problems
1. Heating plates are not heated after the
EN
appliance turn on.
2. Temperature controller has no function.
3. The indicator does not light up.
Aforementioned troubles are just for reference. If any fault occurs, please cease using and contact the supplier.
WARNING!
• Check the operation of the appliance regularly
to prevent problems that can cause serious ac-
cidents.
6
All manuals and user guides at all-guides.com
• Properly dispose of the oil in the drip tray.
• Drop a little edible oil on stubborn residues on
• Wipe the grill plates and the housing with a
• Avoid strong cleaning agents or scouring pads as
• Keep the appliance in a clean and dry location,
• Keep the appliance out of reach of the children.
• When storing the appliance, make sure the stor-
Causes
1. If the thermostat is defective the
orange heating indicator would not be
illuminated.
2. At least one of heating element is
burned.
3. If the Hi-limiter is triggered the orange
indicator would be off.
Temperature controller is defective
Indicator is broken.
• As soon as you feel the appliance isn't working
the grill plates and let these soak for approx. 20
minutes.
slightly damp cloth.
these may damage the grilling plates coorode the
plastic.
away from the direct sunlight.
age space is ventilated and that there are no cor-
rosives near the appliance.
Solutions
1. Contact supplier for repair
2. Contact supplier for repair
3. There is a reset rod on the bottom of the
appliance. There is no need to open the
appliance.
Contact supplier for repair
If the indicator is broken you don't need
to replace the thermostat but you should
contact the supplier.
correctly or there is a problem, stop using the ap-
pliance, shut it off and contact the supplier.