Emergency Procedure - Lippert 10857 Serie Mode D'emploi

8.2 EMERGENCY PROCEDURE

In case of failure while the tread is not completely in the closed position,
the tread can be manually disconnected from the motor unit and moved to
a safe position:
CAUTION
12
LCI Italy s.r.l. or any part of Lippert
Components, Inc. are not liable nor responsible
for any loss or damage or injury caused using the
device after being tamper with, so in case of
critical failure of the device while the tread is not
fully retracted, a full uninstall of the device is
advised. Any emergency procedure is on the
user's responsibility.
1
2
3
1
remove the 2
philips-head screws
holding the bottom
cover.
2
remove the bottom
cover by bending it
slightly outside the
channels and slide it
away.
3
Remove the two
M6 screws using a
X20 "hexalobular"
tool.
4
carefully retract the
tread by hand until
fully retracted.