Bosch sensixx B15L Notice D'utilisation page 10

en
General safety instructions
Important !
• Read these instructions for use carefully
before using the appliance and save them
for future reference.
• This appliance complies with international
safety standards
• Before using for the first time, check if the
voltage rating on the type plate corresponds to
the mains voltage in your home. This appliance
must be connected to an earthed socket.
• If it is absolutely necessary to use an extension
cable, make sure that it is suitable for 10 A or
more and has a socket with an earth connec- -
tion.
• This appliance must only be used for the
purposes it was designed, i.e. as an iron. Any
other use will be considered as improper and
consequently dangerous. The manufacturer will
not be held responsible for any damage arising
from misuse or improper use.
• The electrical plug must not be removed from
the socket by pulling the cable.
• Do not leave the appliance exposed to weather
conditions ( rain, sun , frost, etc ).
• Do not leave the appliance unattended while it
is plugged in.
• Keep the appliance out of children's reach.
• This appliance is not intended to be used by
persons (including children) with reduced phy-
sical, sensory or mental capacities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• Remove the plug from the socket before filling
the appliance with water or before pouring out
the remaining water after use.
• Never immerse the iron or the station in water
or any other fluid.
• The appliance must never be placed under the
tap to fill with water.
• When you have finished ironing, and also when
leaving the iron even for a short while:
10
All manuals and user guides at all-guides.com
- set variable temperature dial to minimum.
- switch the main switch to the –off- position.
- place the iron on its support on the appli
ance.
- remove the mains plug from the wall so
cket.
• Some parts of the iron have been slightly gre
ased and as a result the iron may smell slightly
when switched on for the first time. After a shor
while, however, this will cease.
• Before using the iron for the first time remov
any sticker or protective foil from the soleplat
Clean the soleplate with a soft cloth.
• Do not put vinegar or other descaling agents
into the water tank.
• Do not use distilled water exclusively.
• Do not try to repair any part of the steam statio
on your own.
• If the supply cord is damaged, it must be re-
placed by the manufacturer or its service agen
or a similarly qualified person in order to avo
a hazard.
• When turned on for the first time, your new ir
may smell for up to 10 minutes. This is due to
the initial heating of the used materials. Th
odor is safe and should not reoccur after initia
heating. Moreover, the iron may emit some sma
particles from the steam holes. This is norma
and will not occur after several times using th
¨steam¨ function.
-
• Do not aim iron at other persons or toward
yourself, while using the ¨steam¨ function.
• The filling lid must not be opened during use.
• The appliance must be used and placed on a
stable surface.
• When placed in a support, make sure that the
surface on which the support stands is stable.
• The iron should not to be used if it has been
dropped, if there are visible signs of damage or
if it is leaking water. It must be checked by a
authorized Technical Service Centre before
can be used again.
• Do not allow the mains cord and the supply hose
to come into contact with the soleplate when it
is hot.
-
-
-
-