Electrolux ERN1300AOW Notice D'utilisation page 10

10 www.electrolux.com
Problem
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
Water flows on the floor.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Temperature is set incor-
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' temper-
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
Solution
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
This is correct.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if nec-
essary.
Make sure that there is cold
air circulation in the appli-
ance.