Intended Use - Dometic HIPRO ALPHA A 30S1 Guide Rapide

• Food may only be stored in its orig-
inal packaging or in suitable
containers.
• Opening the door for long periods
can cause significant increase of
the temperature in the compart-
ments of the minibar.
• Clean regularly surfaces that can
come in contact with food and
accessible drainage systems.
• If the minibar is left empty for long
periods:
– Switch off the minibar.
– Defrost the minibar.
– Clean and dry the minibar.
– Leave the door open to prevent
mould developing within the
minibar.
A
NOTICE! Damage hazard
• Only store heavy objects such as
bottles or cans in the minibar door
or on the bottom shelf.
• Do not use electrical devices
inside the minibar unless they are
recommended by the manufac-
turer for that purpose.
• Do not place it near naked flames
or other heat sources (heaters,
direct sunlight, gas ovens etc.).
• Ensure that the ventilation vents
are not covered.
• Never immerse the minibar in
water.
• Protect the minibar and the cable
against heat and moisture.
• Make sure that foodstuffs do not
touch the walls of the cooling area.
I
NOTE
• For ambient temperatures of
+15 °C to +25 °C (+59 °F to
+77 °F), select the average tem-
perature setting.

Intended use

The refrigeration appliance (also referred to as min-
ibar) is designed for operation in enclosed build-
ings, such as:
• In staff kitchens in stores, offices and other work
areas
• In the agricultural sector
• In hotels, motels and other accommodations
• In bed and breakfast establishments
• In catering businesses or similar wholesaler
operations
The minibar is not suitable for installation in cara-
vans or mobile homes.
The minibar is intended to be used either as a built-
in appliance or as freestanding refrigeration appli-
ance. Refer to the installation instructions.
The minibar is designed exclusively for cooling and
storing of beverages and foods in closed contain-
ers.
The minibar is not suitable for storing fresh foods
and medicine or freezing foodstuffs.
This minibar is only suitable for the intended pur-
pose and application in accordance with these
instructions.
This manual provides information that is necessary
for proper installation and/or operation of the min-
ibar. Poor installation and/or improper operating
or maintenance will result in unsatisfactory perfor-
mance and a possible failure.
The manufacturer accepts no liability for any injury
or damage to the product resulting from:
• Incorrect assembly or connection, including
excess voltage
9