Initial Operation - Technoline WS 6760 Guide D'utilisation


Press the button for 3 seconds to enter the temperature alert setting mode

To stop the alarm
D "HISTORY" button

Press the button for 3 seconds to enter the altitude setting mode, to advance and to select
the following settings: height adjustment, weather forecast icon, choose between air
pressure unit hPa or inHg

To stop the alarm
E "CHANNEL" button

Press the button for about 3 seconds to search for an external transmitter on channel 1,2 or
3

change of external temperature channels and continuous switching display of the outside
temperature channels

To stop the alarm
F "SNOOZE / LIGHT" button

Press to activate the snooze function while wake up alarm rings

activation of the backlight

Initial Operation


Open the battery compartment located on the rear side of the outdoorsensor and
weatherstation. Place the batteries in the battery compartment. Please pay attention to the
polarity.

The altitude flashes , please use "+ ", "-"to set the altitude of your position (in meters), then
press "HISTORY", hPa flashes, press the "+", "-" button to select between the air pressure
units hPa and inHG, press "HISTORY", weather symbol flashes, pls use "+ ", "-" to select the
weather symbol that fits the current weather

The station is now connecting to the outdoor sensor. This process takes about 3 minutes.
Then the display shows the outdoor temperature and humidity, in case of failure of reception
please press "CHANNEL" for more than 3 seconds to restart the search process again.

The automatic reception of the DCF radio signal starts after 3 minutes of outdoor reception

While the RCC reception process is going on, the flashing symbol "radio tower" appears in
the time display area

Once radio signal reception was successful, the display shows a static "radio tower" symbol
If, due to bad reception, or no RCC automatic time reception is possible, follow the steps below
for manual time setting
Reception of radio controlled signal

DCF radio signal search starts automatically about 3 minutes after battery exchange. The
"radio tower" signal is flashing.

Press"+" and "-" together for more than 3 seconds to enter or quit the radio controlled signal
reception

The clock synchronizes with the DCF radio signal automatically and daily from AM 1:00 to
3:00 to correct time deviations each hour. If the synchronization is unsuccessful ("radio tower"
symbol disappears), a further synchronization attempt is made from 4:00 and 5:00 until