Initial Operation - Technoline WS9050 Guide D'utilisation

Initial operation:

 Open Weather Station battery compartment cover
 Insert 2 x AA batteries observing polarity [ "+" and " –" marks]
 When you insert the batteries, all icons on the LCD display will light up for 3
seconds, and you will hear a beep tone and the station detects indoor
temperature & humidity.
 The Weather Station will now start the outdoor remote sensor reception.. This
operation takes about 3 minutes and is displayed by a flashing reception RF
antenna symbol in the "OUTDOOR" display area on the receiver.
 Open Wireless Outdoor Sensor battery compartment cover, Insert 2 x AA
batteries observing polarity [ "+" and "–" marks].
 After receiver has a connection to the outdoor remote sensor after 3 minutes, it
will enter the radio controlled time signal reception mode.
Reception of the Radio signal:
 The clock will automatically search the DCF (radio controlled time) signal after 3
minutes of any restart or changing of new fresh batteries. The radio mast icon
starts to flash.
 At 1:00 /2:00 / 3:00 AM, the clock automatically carries out the synchronization
procedure with the DCF signal to correct any deviations to the exact time. If this
synchronization attempt is unsuccessful (the radio mast icon disappears from
the display), the system will automatically attempt another synchronization at
the next full one hour. This procedure is repeated automatically up to total 5
times.
 To start manual DCF signal reception, press and hold down the "DOWN" button
for 3 seconds. If no signals received within 7 minutes then the DCF signal search
stops (the radio mast icon disappears) and will start again at the next full one
hour.
 During DCF reception to stop searching radio signal, press the "DOWN" button
once.
Please note:
 A flashing radio mast icon indicates that the DCF signal reception has started
 A continuously displayed radio mast icon indicates that the DCF signal was
received successfully
WS9050 Manual