Technical Data; Contact Information - EUFAB 21066 Manuel De L'opérateur

Masquer les pouces Voir aussi pour 21066:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

OPERATING INSTRUCTIONS
Pumping up car or bicycle tyres
1.
Undo the 12 Volt cable.
2.
Fit the car valve adapter to the valve.
3.
Start the compressor by connecting the 12 Volt adapter with the 12 Volt connection of your vehicle. Wait until the
required tyre pressure has been achieved.
4.
Separate the 12 Volt connection from the vehicle and remove the car valve adapter from the tyre valve.
Note: Check the tyre pressure of your vehicle using the recommended values in the operating instructions to avoid over
pressure. Bicycle tyres should be checked using the tyre designation.
Pumping up sports equipment (e.g. basket balls) or balloons
1.
Undo the 12 Volt cable.
2.
Screw the ball/balloon adapter to the threaded connector at the hose end.
3.
Insert the ball/balloon adapter into the valve of the object you wish to pump up.
4.
Start the compressor by connecting the 12 Volt adapter with the 12 Volt connection of your vehicle. Wait until the
desired firmness has been achieved or the object is completely pumped up.
5.
Remove the adapter from the valve of the pumped up object and unscrew to the remove the threaded connector
at the hose end.
6.
To switch off the compressor, separate the link with the 12 Volt connection.
Note: During pumping the manometer only offers an estimated value. A precise pressure value cannot be read off.
CAREFUL
Do not generate overpressure, this may lead to injury or destruction of the device. Do not
leave the compressor unattended when in use! Allow the compressor 30 minutes to cool
down for every 10 minutes of constant operation.

TECHNICAL DATA

• Operational voltage: 12 Volt
• Maximum pressure: 17 bar / 250 PSI
• Power supply: 12 Volt
NOTES REGARDING ENVIRONMENTAL PROTECTION
The packaging is made up of environmentally friendly materials which may be disposed of via your
local recycling points.
Do not put electrical devices into the household waste. Electronic and electrical devices must be
collected separately and sent for environmentally friendly recycling. Contact your community or
town administration for information regarding the disposal of electrics.

CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
All manuals and user guides at all-guides.com
• Size (L x W x H): Approximately 15 x 6.5 x 13 cm
• Weight: Approximately 620 g
• Accessories: 3 adapters
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
5

Publicité

Table des Matières
loading

Table des Matières