Control Of The Led Lighting; Troubleshooting - Carson Beat Warrior Buggy Manuel

controL oF tHe LeD LIgHtIng

1 Your RC-Car is equipped with LED-lights in the front and back-
side.
2 The picture shows the switch which controls the lighting. You
can switch the lighting on and off with it.
2

troubLeSHootIng

Problem
model doesn´t move
loss of control
Doesn´t run straight
Doesn´t stop
Doesn´t reverse
Running too slowly
GB // 18
cAuTIoN!
3 The installed lighting does not replace the daylight. Therefore,
please do not drive your model at night or in the dark. Such
obstacles can not be perceived soon enough. Thank you and
have fun!
Switch for
the lighting
Cause
Transmitter or chassis power switch is not
"ON"
Polarity or battery type is wrong
Batteries have run down
Batteries have run down
Antenna is missing or not attached properly
Steering trim is not adjusted correctly
Front and rear wheel nuts are too lose
Throttle trim is not adjusted correctly
Throttle trim is not adjusted correctly
Wrong action
Batteries have run down
Motor has lost power
Rear wheel nuts are too lose
Dust or foreign objects are inside gears
Correction
Switch power on receiver or transmitter
Check polarity and type of battery
Change batteries or charge them
Change batteries or charge them
Attach receiver antenna
Make adjustment
Tighten wheel nuts
Make adjustment
Make adjustment
Control properly
Change batteries or charge them
Change to spare motor
Tighten wheel nuts
Turn the power switch "OFF" and clean out
gears