Switching On For The First Time - Fagor Xperta CAT 44 NG Manuel D'utilisation

All manuals and user guides at all-guides.com
Remove the water tank from the cof-
fee machine (Fig. 7).
Fill the water tank with fresh cold
water (Fig. 8).
Pour only fresh cold water in the water
tank. Never put in other liquids, e.g.
mineral water or milk.
Replace the water tank (Fig. 7). Press
the tank firmly in, to ensure that the
water tank valve opens.
If for instance, water has to be refilled
during coffee dispensing, the „Fill
water tank" indicator (Fig. 3, k)
flashes, the display indicates «REFILL
WATER». Coffee preparation is inter-
rupted. Fill the water tank!
To always be sure of a rich coffee, with
a full aroma, you should:
• change the water in the water tank
daily,
• wash the water tank at least once per
week in normal washing-up water (not
in the dishwasher). Then rinse with
fresh water.
5.3

Switching on for the first time

When you place the machine in use for
the first time, the automatic switching
on process only continues if you have
selected the desired language.
Switch on the mach ine with the „On/
Off" key (Fig. 3, h)
indicator light comes on
The machine is set at the factory to the
display language
To select a different language, proceed
with „Setting language" page 45.
If you wish to select
press the „OK" key (Fig. 3, g). English is
now programmed.
After programming the display returns
automatically in the main menu to the
menu point «LANGUAGE».
5.4
(Fig. 9). The red
«ENGLISH ».
«ENGLISH »,
To start the switching on process, press
the „Menu" key (Fig. 3, f)
ca. 30 sec. For the machine to auto-
matically start with the switching on
process.
The display briefly indicates «Xperta».
The machine now heats up (display
HEATS») and sub-
indication «UNIT
sequently performs a rinsing cycle (dis-
RINSES»). On
play indication «UNIT
completion of the rinsing cycle, the
machine is ready for use. The display
indication now appears according to
the basic setting.
Switching on the machine
Each time before switching on, make
sure there is water in the water tank
and replenish if necessary. The machine
requires water for the automatic rins-
ing cycles with each switching on and
switching off process.
Switch the machine on with the „On/
Off" key (Fig. 3, h) (Fig. 9). The red
indicator light comes on, the display
indicates briefly «Xperta».
Immediately after being switched on
the machine runs through a set-up
cycle. The noises occurring are per-
fectly normal.
During the heating-up phase (ca.
60 seconds) the „Coffee machine heat-
ing" indicator (Fig. 3, i) flashes (dis-
HEATS»).
play indication «UNIT
After the operating temperature has
been reached, the coffee machine car-
ries out an automatic rinsing cycle.
(display indication «UNIT
The water flows into the drip tray. The
„Unit heats" indicator (Fig. 3, i) lights
continuously.
The coffee machine is now ready to
use. The indication shown in the dis-
play depends on the last selected cof-
fee mode.
GB
or wait
RINSES»).
13