Lock-Release Timing - Fermax DUOX VIDEO F7391 Manuel D'installation

DUO DUO X Pr X Pr o o o o o g g g g g r r r r r amming X Pr
DUO DUO X Pr DUO X Pr
DUO DUO X Pr o o o o o g g g g g r r r r r amming X Pr X Pr
DUO X Pr
DUO DUO X Pr
ADVANCED PROGRAMMING.

Lock-Release Timing

There are two programmable lock-release activation times:
- Lock-release time set from the residence.
- Lock-release time set from the exit button (connected
to the 'BS' and '-' terminals).
BUTTON Panel Programming
Carry out the following steps:
1. With the power supply disconnected, short circuit the
«Bs» and «-» (negative) amplifier terminals.
2. Maintaining the aforementioned short-circuit connects
the power system. After about 60" (the time the panel
takes for start-up), the amplifier will generate as many
''beeps'' as seconds programmed for the opening time
from the residence.
2.1.If you want to change this value, you must press
any call button as often as the seconds you wish to
program.
2.2.If you do not want to change, just wait 10 seconds
without pressing any call button.
amming amming
amming amming
amming amming
amming
amming
Pag 31