Fermax DUOX VIDEO F7391 Manuel D'installation page 25

DUO DUO X Pr X Pr o o o o o g g g g g r r r r r amming X Pr
DUO DUO X Pr DUO X Pr
DUO DUO X Pr X Pr o o o o o g g g g g r r r r r amming X Pr
DUO X Pr
DUO DUO X Pr
1. Inverse Programming. (2 operators are required).
This mode allows you to assign non-sequential call codes
(addresses).
The steps to be followed are detailed below:
1. Previously configure the panel as MASTER panel, (see
previous page).
2. Program the monitor locally and independently via an
entry panel or Guard unit (when available). See the
NOTE on the next page.
3. Enter in the «inverse button programming» mode on
the amplifier:
Press the SW1 button and hold for 10 seconds until you
hear a «beep.» Stop pressing the SW1 button. The
Mode Led (DL2) is activated to indicate that we entered
in an inverse programming mode (slow blink): 1 flash /
second 10%).
4. Assign the new addresses to each button:
4.1.Enter into programming in the home terminal; you
will hear a programming entrance tone and upon
picking up you enter in conversation with the master
street panel.
4.2.With the monitor off the hook, on the entry panel
press the call button associated with the home.
amming amming
amming amming
amming amming
amming
amming
Pag 25