Micropilot NMR84
Tank level
Navigation
Description
Information
supplémentaire
Set level
Navigation
Description
Entrée
Réglage usine
Information
supplémentaire
Water level source
Navigation
Description
Sélection
Réglage usine
Information
supplémentaire
Endress+Hauser
Setup → Advanced setup → Application → Tank config → Level → Tank level
Shows the distance from the zero position (tank bottom or datum plate) to the product
surface.
Accès en lecture
Accès en écriture
Setup → Advanced setup → Application → Tank config → Level → Set level
If the level measured by the device does not match the actual level obtained by a manual
dip, enter the correct level into this parameter.
0...100 000 mm
0 mm
Accès en lecture
Accès en écriture
L' a ppareil ajuste le paramètre Empty (→ 115) en fonction de la valeur entrée, de sorte
que le niveau mesuré corresponde au niveau réel.
Setup → Advanced setup → Application → Tank config → Level → Water level src
Defines the source of the bottom water level.
• Manual value
• Bottom level
• HART device 1 ... 15 level
• AIO B1-3 value
• AIO C1-3 value
• AIP B4-8 value
• AIP C4-8 value
Manual value
Accès en lecture
Accès en écriture
Operator
-
Operator
Maintenance
Operator
Maintenance
Menu de configuration
169