Troubleshooting; If The Appliance Does Not Work As It Should - Dirt Devil NAVIGATOR M608 Mode D'emploi

7 Troubleshooting

7.1 If the appliance does not work as it should

See if you can solve the problem yourself by following the steps in the table below. If you cannot
solve the problem using this table, contact our Customers Service (ZPage 202, 'International Ser-
vice') and describe the problem to us.
Problem
The appliance will The battery pack is not connected correctly.
Connect the battery pack correctly, ZChapter 7.8, "Removing/replacing
not start.
the battery pack".
The battery pack is completely empty.
Switch off the appliance via the On/Off switch (position "0") and charge the
battery pack as described, ZChapter 3.4, "Charging the battery pack for
the first time".
The toggle switch underneath the robot is not switched to "on" position
("0").
Switch the toggle switch to "on" position ("I"), ZChapter 3.4, "Charging the
battery pack for the first time".
Perhaps you tried to start the appliance docked to the docking station and
charging. Wait until charging is completed.
Perhaps you tried to start the appliance via remote control but the battery
of the remote control is completely empty. Change this battery, ZChapter
7.4, "Changing the side brush".
Red LED is blinking The capacity of the battery pack is too weak.
fast while the blue
Your robot should dock onto the docking station by itself. If it does not - for
whatever reason - charge the battery pack as described, ZChapter 3.4,
LED is lit constantly.
"Charging the battery pack for the first time".
Red and blue LED The dust bin is not installed or not installed correctly.
blinking fast in com-
Switch off your robot via the "On/Off" key (
remote control and insert dust bin module correctly, ZChapter 6.2, "Emp-
bination with 30 sec-
onds of short beep-
tying the dust bin module".
ing
Blue LED is lit and Drive wheel, side brush or main brush stuck.
red LED is blinking
Switch off your robot via the "On/Off" key (
fast in combination
remote control and remove dirt from wheels and brushes, ZChapter 7.3,
with 2 long beeps
"Removing and cleaning the main brush". If necessary, carefully use scis-
sors or tweezers.
Red LED is blinking All 3 cliff sensors are triggered.
fast and blue LED is
Move robot to an area without cliffs and restart.
blinking slowly in
combination with
2 long beeps
All manuals and user guides at all-guides.com
Possible cause / solution
7 Troubleshooting
) or the "
) or the "
" key on the
" key on the
53