Toro V-21S Manuel De L'utilisateur page 20

POTENTIAL HAZARD
Adjusting height-of-cut levers could bring
hands into contact with moving blade.
WHAT CAN HAPPEN
Contact with rotating blade can cause
serious injury.
HOW TO AVOID THE HAZARD
Stop engine and wait for all movement to
stop before adjusting cutting height.
Do not put fingers under housing when
adjusting height-of-cut.
2. For easier adjustment, lift housing up so wheel is
off ground. Do not place hands under deck
when lifting housing. Squeeze adjusting lever
EN–10
All manuals and user guides at all-guides.com
3.
toward wheel and move it to the desired setting
(Fig. 13). Ensure pin on adjusting lever engages
hole in bracket.
Note: Front wheels can be adjusted to 1/2
inch. Move adjusting lever past "1"
and release pin into slot in housing. It
is not recommended that the 1/2 inch
height-of-cut setting be used on a
regular basis.
In conditions when maximum power is required
or when cutting in spongy thatch that causes rear
wheels to sink in turf, raise rear wheel setting
one increment higher. Make sure wheel settings
are returned to equal settings, when cutting in
normal conditions, to achieve the best quality of
cut.