CONNECTING EQUIPMENT TO THE TWR-5
Connecting to Wireless Loadbars
1.
On the TWR-5, tap
Wireless
.
2.
The TWR-5 will search for the loadbars. When the loadbars have been located,
tap to select them from the list, then tap
Note: As per the Wireless Loadbar Installa on instruc ons, your loadbars
must be switched on and in range to display in the search list.
3.
The connec on process will take up to 30 seconds while pairing occurs
between the loadbars and the TWR-5. Once completed, tap
4.
Create a new session, by tapping
display as 0.0kg. If it's not 0.0, press the
the bars to confi rm the connec on is working.
Note: A er 15 minutes of inac vity, wireless loadbars will disconnect as TWR-5
goes into sleep mode. Press
re-connect.
Connecting an EID Reader
•
The TWR-5 internal reader can be used with or without loadbars connected.
To use the internal reader, you must fi rst connect the antenna panel. Refer to
A aching the TWR-5 to the Antenna panel (p. 6).
•
A Hand-held EID Reader or permanent reader can be connected to the TWR-
by either a serial cable or via Bluetooth®.
5.
If using a hand-held reader or permanent reader, turn On the EID Reader.
6.
For all readers, turn On the TWR- .
7.
On the TWR- , tap
8.
Select how the Reader is being connected. This will be by Bluetooth, Serial
cable, USB or using the internal reader (Panel).
If using the internal reader, a successful connec on will show as
footer bar.
Note: A mini serial adapter is included with the TWR- if a female serial
connec on is required.
Important: You can also connect to your TWR-5 by ini a ng a Bluetooth®
enabled connec on from your reader. A pass-code of "0000" may be required
to complete this connec on.
8
Gallagher TWR- Weigh Scale Quick Start Guide
Se ngs > Equipment Connec ons > Loadbars >
New > Quick Start
Power
bu on and go to the Weigh screen to
Se ngs
> Equipment Connec ons > EID Reader
Connect
.
. The current weight will
Zero
bu on. Apply some weight to
Done
.
.
in the